Create accountLogin

Recent searches

No recent searches

Search options

Only available when logged in.
sfba.social is one of the many independent Mastodon servers you can use to participate in the fediverse.
A Mastodon instance for the San Francisco Bay Area. Come on in and join us!

Administered by:

Server stats:

2.4K
active users

sfba.social: AboutProfiles directoryPrivacy policy

Mastodon: AboutGet the appKeyboard shortcutsView source codev4.3.4

#wing

1 post1 participant0 posts today
Public
TomKrajci 🇺🇦 🏳️‍🌈 🏳️‍⚧️

How to remove/demold a part from a fragile part. (Hint: You can create shear in more than one way, and it may be better than creating a peeling action with hammer and chisel.)

The blue Styrofoam that served as the form will be destroyed as it's removed from the fiberglass wingtip weel, but it's a one-off form/mold that lacked any taper.

(This is a follow up to universeodon.com/@KrajciTom/11 )

#avgeek #aviation #ElectricAircraft #ExperimentalAviation #homebuilt
#Glider #DIY #Wing #Epoxy #Fiberglass #Composite #Shear #Peel

No! You risk damaging the wing's surface this way. (OK, you could use a plastic/rubber wedge, but let's try a finesse method first...)
The long clamp squeezes on both ends of the fiberglass part...never touching the wing. This squeeze causes the base of the fiberglass part to bow outwards...shearing along the surface of the wing.
Only light force was applied to tighten the clamp...and the part easily popped off.
Public
TomKrajci 🇺🇦 🏳️‍🌈 🏳️‍⚧️

Making a custom wingtip wheel for my glider's right wing.

The bottom of the wingtip was covered with clear packing tape, then lightly waxed.

Hot glue temporarily attached the blue Styrofoam mold/form, which also contains the 60mm diameter roller blade wheel.

The part is made from seven plies of 7725 weave fiberglass that will be cut into a triangular shape after wetting with epoxy.

No vacuum bag, so this is a hand lay up. I had to use some small pieces of metal to coax the fiberglass to stay in the correct place.

The garage will be heated overnight so that the part cures, then some tugging and a rubber mallet should separate the part.

#avgeek #aviation #ElectricAircraft #ExperimentalAviation #homebuilt
#Glider #DIY #Wing #Epoxy #Fiberglass #Composite

The underside of the wing tip has been covered in clear packing tape, then waxed.
This is one ply of dry fiberglass, colored white, laying over a piece of green plastic sheet. Faintly visible through the fiberglass is a triangular pattern. After wetting seven plies, I will cut the fabric to that triangular shape. That shape will drape over the form and make the part in one step. The two edges of the open triangle will join and overlap along the trailing edge of the part, aft of the wheel.
Wetted fiberglass has a green tint. Scrap metal helps hold the fabric in the correct location. Strips of light brown fabric are Teflon coated fiberglass, which serves as peel ply. I'm using it to also help coax the fiberglass into the desired shape.
ExploreLive feeds
About